Application Instructions
Follow these steps for perfect DTF transfer application every time
Step-by-Step Process
Set your heat press to 300°F (150°C) and allow it to reach temperature.
Ensure the heat press is fully preheated for consistent results. This typically takes 10-15 minutes.
Press the garment for 5-10 seconds to remove moisture and wrinkles.
This step ensures a smooth, dry surface for optimal transfer adhesion.
Place the DTF transfer face-down on the garment in your desired location.
Make sure the design is centered and straight. You can use heat-resistant tape to secure it if needed.
Press at 300°F for 12-15 seconds with medium to firm pressure.
Apply consistent, even pressure across the entire design. Do not move or shift the press during application.
Immediately peel off the transfer film while still hot in one smooth motion.
Peel slowly and steadily from one corner. The design should transfer completely to the fabric.
Cover with parchment paper and press for 5-10 seconds for extra durability.
This final press helps set the transfer and ensures maximum wash durability.
Temperature
300°F
(150°C)
Press Time
12-15s
Medium-firm pressure
Peel Type
Hot Peel
Immediately after pressing
Second Press
5-7s
Optional — for extra durability
Wait 24 hours before first wash for optimal adhesion
Machine wash inside-out in cold water
Tumble dry low or hang dry
Do not iron directly on the transfer
Avoid bleach and fabric softeners